Panasonic PT-60LCX64-K Service Manual page 55

3. 1) Disconnect Connector P2904, and remove the Fan 3 Unit by removing the 2 Screw (402).
2) Remove the Top Duct 3 Unit by removing the 4 Screws (421).
CAUTION:
When removing the Screws (421) on the Top Duct 3 Unit, plastic dust may be produced. Therefore, confirm that there is no dust
on the Top Duct 3 Unit. If there is dust, clean the Top Duct 3 Unit with a brush, etc. Otherwise, dust may adhere to the inside of
the screen.
3) Remove the Lamp from the Projection Unit by loosening the Screw.
Screw
for lamp
P2904
Replacement Note of Projection Unit (Ref. No. 21):
These parts will be necessary when replacing the Projection Unit (Ref.No. 21). Set aside, and keep and re-use.
• Fan 3 Unit
• Top Duct 3 Unit
21
Lamp
Projection Unit
Clamper
421
Fig. D2-3
55
Fan 3 Unit
GND
Wire
402
421 402
Top Duct 3 Unit
PT-60LCX64-K