Security Menu - Getac V200 User Manual

Security Menu

The Security menu contains the security settings, which safeguard your
system against unauthorized use.
Main
Supervisor Password Is:
User Password Is:
Set Supervisor Password:
Set User Password
Password on boot:
TPM Support
F1 Help
Esc Exit
Supervisor/User Password Is shows whether you have set the
supervisor/user password or not for the system.
Set Supervisor/User Password sets the supervisor/user password. When
typing the password, first make sure that Num Lock is off, and then type the
password in the entry fields and press Enter. Confirm your password by
typing it again and pressing Enter. You can set the supervisor/user password
to be required for starting up the system and/or entering BIOS Setup.
NOTE:
You can set the user password only when the supervisor password has
been set.
If both the administrator and user passwords are set, you can enter any
of them for starting up the system and/or entering BIOS Setup.
However, the user password only allows you to view/change the settings
of certain items.
5-6
Using BIOS Setup and System Recovery
Advanced Security
Set
Clear
[Enter]
Enter
[Enter]
[Disabled]
[Disabled]
Select Item -/+
↑↓
Select Menu Enter
←→
Boot Exit
Item Specific Help
Supervisor Password
controls access to the
setup utility.
Change Values
Select Sub-Menu
F9 Setup Defaults
F10 Save and Exit