Display Problems - Getac V200 User Manual

Display Problems

Nothing appears on the screen.
During operation, the screen may automatically turn off as a result of

power management. Press any key to see if the screen comes back.
The brightness level might be too low. Increase brightness.

The display output might be set to an external device. To switch the

display back to the LCD, press the Fn+F5 hot key or change the display
through the settings in Display Properties.
The characters on the screen are dim.
Adjust the brightness and/or contrast.

The display brightness cannot be increased.
As a protection, the display brightness will be fixed at a low level when

the surrounding temperature is too high or too low. It is not a
malfunction in this situation.
Bad dots appear on the display at all times.
A small number of missing, discolored, or bright dots on the screen are

an intrinsic characteristic of TFT LCD technology. It is not regarded as a
LCD defect.
Resolution cannot be adjusted to desired setting.
Make sure that the VGA driver is installed correctly.

The external monitor displays nothing.
Make sure that the monitor is turned on.

Make sure that the monitor's signal cable is properly connected.

Switch the display to the monitor by pressing the Fn+F5 hot key or

change the display through the settings in Display Properties.
Simultaneous display/multi-display does not work.
Make sure that you turn on the external monitor before turning on the

computer.
8-4
Troubleshooting