Your Computer - Getac V200 User Manual

Ring Wake Up From S3 allows a modem device activity to wake up the
system from S3 (Sleep) state.
USB Wake Up From S3 allows a USB device activity to wake up the
system from S3 (Sleep) state.
Wake on PCH LAN allows a LAN activity to wake up the system from S3
(Sleep) state.
System Policy sets if the system always runs at full speed (
lowers down when its temperature is too high (
AC Initiation sets if connecting AC power will automatically start or resume

your computer.

SATA Mode set to
take advantage of Advanced Host Controller Interface features. The options
IDE AHCI
are and
CAUTION: Incorrect SATA mode settings can result in hard disk drive boot
failure.
AMT Configuration configures Active Management Technology parameters.
Press Enter to access the submenu as shown below.
Intel AMT:
Intel AMT Setup Prompt:
F1 Help
Esc Exit
5-6
Using BIOS Setup and System Recovery
AHCI
if your hard disk supports AHCI. AHCI allows you to
.
Advanced
AMT Configuration
[Disable ]
[Disabled]
↑↓
Select Item +/-
←→
Select Menu Enter
Balance
Enabled
Change Values

Select Sub-Menu
Performance
).
Item Specific Help
Enable/Disable
Intel (R) Active
Management Technology
BIOS Extension.
Note: iAMT H/W is
always enabled.
This option just
controls the BIOS
extension execution.
If enabled this
requires additional
firmware in the SPI
device
F9 Setup Defaults
F10 Save and Exit
) or