Display Problems - Getac V100 Operation Manual

Make sure that both devices are compatible.

Display Problems

Nothing appears on the screen.
During operation, the screen may automatically turn off as a result of
power management. Press any key to see if the screen comes back.
The brightness level might be too low. Increase brightness by
pressing the
The display output might be set to an external device. To switch the
display back to the LCD, press the
display through the settings in Display Settings Properties.
The characters on the screen are dim.
Adjust the brightness and/or contrast.
Bad dots appear on the display at all times.
A small number of missing, discolored, or bright dots on the screen
are an intrinsic characteristic of TFT LCD technology. It is not
regarded as a LCD defect.
Resolution cannot be adjusted to desired setting.
Make sure that the VGA driver is installed correctly.
The external monitor displays nothing.
Make sure that the monitor is turned on.
Make sure that the monitor's signal cable is properly connected.
Switch the display to the monitor by pressing the
change the display through the settings in Display Settings Properties.
Simultaneous display/multi-display does not work.
Make sure that you turn on the external monitor before turning on the
computer.
Troubleshooting
hot key.
Fn+F6
+ hot key or change the
Fn F9
Fn
+ hot key or
F9
8-5