Left & Right Guide Stackers / Cdr Guide Sensor - Epson Stylus PhotoR280 Service Manual

EPSON Stylus Photo R280/R285/R290
4.4.7 Left & Right Guide Stackers / CDR Guide Sensor
Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy / Upper Housing / Main Board Unit / Panel Assy /
Cover Open Sensor / Printer Mechanism
Removal procedure
Be careful of the seven sharp edges shown in
assembling or reassembling.
Left / Right Guide Stacker Removal
1. Remove the screw and remove the Left Guide Stacker.
• Screw : C.B.P. M3x8 (tightening torque: 5-7 kgf.cm)
2. Remove the screw and remove the Right Guide Stacker.
Screw : C.B.P. M3x8 (tightening torque: 5-7 kgf.cm)
•
Left Guide Stacker
Left Guide Stacker
Sharp edge
Figure 4-64. Removing the Left / Right Guide Stacker
Chapter 4 Disassembly/Assembly
Fig.4-64 when
(No.3)
(No.3)
Right Guide Stacker
4.4.7 Left & Right Guide Stackers / CDR Guide Sensor (Disassembling the Printer Mechanism)
When installing the Left Guide Stacker, insert the rib indicated
with in Fig.4-65
pins indicated with
When installing the Right Guide Stacker, match the
positioning holes and guide pins indicated with
pairs) in Fig.4-65.
Left Guide
Stacker
Figure 4-65. Installing the Left / Right Guide Stacker
CDR Guide Sensor Removal
1. Disengage the two hooks on the back of the CDR Guide Sensor and remove
the CDR Guide Sensor.
Right Guide Stacker
CDR Guide Sensor
Figure 4-66. Removing the CDR Guide Sensor
Revision B
and match the positioning holes and guide
(two pairs).
(two
Right Guide
Stacker
[Back Side]
Hooks
78