Epson Stylus PhotoR280 Service Manual page 82

EPSON Stylus Photo R280/R285/R290
When installing the EJ Frame Assy, be careful of the following:
Lubrication is required. See the page given below for the
lubrication information.
Lubrication of EJ Frame Assy (p.115)
As shown in Fig.4-77, insert the two bearings of the EJ Frame
Assy over the EJ Roller Shaft.
EJ Frame Assy
Bearing
Figure 4-77. Reinstalling the EJ Frame Assy
When installing the EJ Frame Assy, make sure that the Left/Right
EJ Frame Springs are attached as shown in Fig.4-78. Carefully
handle the EJ Frame Assy as the springs come off easily.
[Left Side]
Opposite
to HP
Shorter Left EJ Frame Spring
Figure 4-78. Reinstalling the Front Frame (1)
Chapter 4 Disassembly/Assembly
Bearing
EJ Roller Shaft
[Right Side]
HP Side
Right EJ Frame Spring Longer
4.4.9 EJ Frame Assy (Disassembling the Printer Mechanism)
When installing the Front Frame, screw it after securing the foot
of the two EJ Frame Springs to the slits as shown in the figure.
Carefully handle the EJ Frame as the springs come off easily.
[Left Side]
Opposite
to HP
Left EJ Frame Spring
Figure 4-79. Reinstalling the Front Frame (2)
When installing the Cable Holder Frame, match the two hooks
of the Cable Holder Frame with the positioning holes of the
Main Frame and Front Frame as shown in
tighten the screws in the order given in the figure.
When installing the Cable Holder Frame, attach the PF
Encoder FFC along with the reference line shown in
(p.81).
When installing the Front Frame, match the positioning holes
of the Front Frame with the guide pins of the Main Frame (two
pairs), and tighten the screws in the order given in
(p.81).
Whenever the EJ Frame Assy is removed or replaced, the required
adjustments must be carried out.
Refer to "5.1.2 Required Adjustments" (p.99)
•
Revision B
[Right Side]
HP Side
Right EJ Frame Spring
Fig.4-73 (p.81), and
Fig.4-74
Fig.4-75
82