Removing Exterior Parts/Components; Printer Cover; Paper Support Assy - Epson Stylus PhotoR280 Service Manual

EPSON Stylus Photo R280/R285/R290

4.2 Removing Exterior Parts/Components

4.2.1 Printer Cover

Parts/Components need to be removed in advance: Nothing
Removal procedure
1. Pull out the left shaft and right shaft of the Printer Cover, and remove the
Printer Cover.
Printer Cover
Shaft (left)
Figure 4-9. Removing the Printer Cover
Chapter 4 Disassembly/Assembly
Shaft (right)
4.2.1 Printer Cover (Removing Exterior Parts/Components)

4.2.2 Paper Support Assy

Parts/Components need to be removed in advance: Nothing
Removal procedure
1. Open the Paper Support Assy.
2. Disengage the right shaft of the Paper Support Assy from the bushing of the
ASF Unit by pushing the bushing outward. Then remove the Paper Support
Assy, disengaging the left shaft preventing the Edge Guide projection from
hitting against the other parts.
Paper Support Assy
Push
Bushing of the ASF
Figure 4-10. Removing the Paper Support Assy
When reinstalling the Paper Support Assy, match the projection
and hole of the Edge Guide, then attach the right shaft and the left
shaft in that order. (Put the shafts at the front side in the bushing
and then push them rearward.) After reinstalling, check that the
Paper Support Assy moves smoothly.
2
Mounting Direction
(from front side to rear side)
Figure 4-11. Reinstalling the Paper Support Assy
Revision B
Edge Guide
Projection
Paper Support Assy
Convex Portion
Hole
:Shaft
1
: Shaft
58