Left & Right Guide Stackers / Cdr Guide Sensor - Epson Stylus Photo R280 Service Manual

Epson Stylus Photo R280/R285/R290/Epson Artisan 50/Epson Stylus Photo T50/T59/T60/P50
Whenever the Waste Ink Pad is replaced, the required
A D J U S T M E N T
R E Q U I R E D
adjustments must be carried out.
Refer to "5.1.2 Required Adjustments" (p.107)
•
Chapter 4 Disassembly/Assembly 4.4.7 Left & Right Guide Stackers / CDR Guide Sensor (Disassembling the Printer Mechanism)
4.4.7 Left & Right Guide Stackers / CDR Guide Sensor
Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy / Upper Housing / Main Board Unit / Panel Assy /
Cover Open Sensor / Printer Mechanism
Removal procedure
Be careful of the seven sharp edges shown in
C A U T I O N
assembling or reassembling.
Left / Right Guide Stacker Removal
1. Remove the screw and remove the Left Guide Stacker.
• Screw : C.B.P. M3x8 (tightening torque: 5-7 kgf.cm)
2. Remove the screw and remove the Right Guide Stacker.
Screw : C.B.P. M3x8 (tightening torque: 5-7 kgf.cm)
•
Left Guide Stacker
Left Guide Stacker
Sharp edge
Figure 4-64. Removing the Left / Right Guide Stacker
Revision C
Fig.4-64 when
(No.3)
(No.3)
Right Guide Stacker
81
Confidential