Epson Stylus PhotoR280 Service Manual page 89

EPSON Stylus Photo R280/R285/R290
4. Remove the Torsion Spring 137.7 from the LD Roller Guide.
Torsion Spring
LD Roller Guide
Figure 4-98. Removing the LD Roller Guide (2)
Removing the ASF Unit
1. Release the following cables from the ASF Unit.
• CR Motor Cable
• PF Motor Cable
PE Motor Cable
•
ASF Unit Hook
Figure 4-99. Releasing the Cables
2. Remove the two screws on the rear side.
Screw : C.B.S.(P4), M3x6
•
(tightening torque: (1) 7-9 kgf.cm, (2) 9-11 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.
[Rear Side]
1
ASF Unit
Figure 4-100. Disengaging the Hooks (ASF Unit)
Chapter 4 Disassembly/Assembly
(No.8)
)
2
4.4.14 ASF Unit (Disassembling the Printer Mechanism)
3. Disengage the two hooks (1) (2) that secure the ASF Unit from the Main
Frame.
4. Remove the Combination Gear (10,15.2), then remove the ASF Unit while
releasing the edge of the Change Lever from the hole of the Main Frame.
Change Lever
[Rear Side]
Combination
Gear
Figure 4-101. Removing the ASF Unit
Revision B
Hook (1)
Hook (2)
Removal Direction
ASF Unit
89