Epson Stylus PhotoR280 Service Manual page 81

EPSON Stylus Photo R280/R285/R290
4. Disconnect the PF Encoder FFC from the PF Encoder.
5. Remove the two screws, disengage the two hooks of the Cable Holder Frame
from the Front Frame and Main Frame, and remove the Cable Holder Frame.
6. Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
[Back Side]
Hook
Figure 4-73. Removing the Cable Holder Frame
7. Peel off the PF Encoder FFC from the back of the Cable Holder Frame.
Cable Holder Frame
Cable Holder Frame
Reference Line
Figure 4-74. Removing the PF Encoder FFC
Chapter 4 Disassembly/Assembly
(No.1)
Cable Holder Frame
2
1
PF Encoder FFC
[Back Side]
PF Encoder FFC
4.4.9 EJ Frame Assy (Disassembling the Printer Mechanism)
8. Remove the screws on the right and left sides, and remove the Front Frame.
• Screw : C.B.S. M3x6 (tightening torque: 7-9 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
1
Figure 4-75. Removing the Front Frame
9. Release the CDR Sensor Cable from the cable guide of the EJ Frame Assy.
10. Remove the EJ Frame Assy.
Removal Direction
CDR Sensor Cable
Cable Guide
Figure 4-76. Removing the EJ Frame Assy
Revision B
(No.1)
2
Front Frame
Positioning hole
and Guide Pin
EJ Frame Assy
81