Ej Frame Assy - Epson Stylus PhotoR280 Service Manual

EPSON Stylus Photo R280/R285/R290
5. Remove the Ink System in the following procedures.
1.Slide it to the right.
2.Rotate it in the direction of the arrow (1) and release the pump part from
the Main Frame.
3.Pull it out toward you (arrow (2)).
Pump
Figure 4-70. Removing the Ink System (2)
When installing the Ink System, be careful of the following:
Lubrication is required. See the page given below for the
lubrication information.
Lubrication of Ink System (p.117)
Insert the shafts of the Ink System into the positioning holes
( ) of the Frame.
Figure 4-71. Reinstalling the Ink System (1)
Tighten the screws in the order given in Fig.4-68.
After installing the Ink System, check the Carriage Lock for
proper operation referring to the section given below.
• "4.1.8 How to Unlock the Carriage"
Insert the positioning hole of the Ink System shown in
over the guide pin of the ASF Unit.
Chapter 4 Disassembly/Assembly
1
2
Fig.4-69
4.4.9 EJ Frame Assy (Disassembling the Printer Mechanism)

4.4.9 EJ Frame Assy

Parts/Components need to be removed in advance
Printer Cover / Paper Support Assy / Upper Housing / Main Board Unit / Panel Assy /
Cover Open Sensor / Printer Mechanism
Removal procedure
1. Move the CR Unit to the home position side.
2. Release the Head FFC from the two hooks of the Cable Holder Frame and pull
out the Head FFC through the cutout.
3. Release the Head FFC from the three hooks of the Front Frame and peel off
the double-sided tape.
[Rear Side]
Front Frame
Head FFC Double-sided Tape
Figure 4-72. Removing the Head FFC
Revision B
Cable Holder Frame Cutout
Hook
Acetate Tape Position
80