Epson Stylus PhotoR280 Service Manual page 70

EPSON Stylus Photo R280/R285/R290
When removing the Waste Ink Tube, take care not to
contaminate the printer and surroundings with ink.
Extra care must be exercised not to scratch or damage the
Waste Ink Tube.
2. Pull out the Waste Ink Tube by hand.
Waste Ink Tube
Figure 4-38. Removing the Waste Ink Tube
3. Release the Waste Ink Tube from the groove
4. Release the CR Motor Cable from the two ribs
CR Motor Cable
Waste Ink Tube Waste Ink Tube
Figure 4-39. Removing the Printer Mechanism (1)
5. Remove the screw and remove the Cover Case.
Screw : C.B.P. M3x8 (tightening torque:5-7 kgf.cm)
Figure 4-40. Removing the Cover Case
Chapter 4 Disassembly/Assembly
of the Waste Ink Tray.
of the Waste Ink Tray.
Waste Ink Tray
(No.3)
Cover Case
4.4.1 Removing the Printer Mechanism (Disassembling the Printer Mechanism)
6. Disconnect the connector of the CDR Guide Sensor.
Figure 4-41. Removing the Printer Mechanism (2)
7. Remove the five screws and remove the Printer Mechanism.
Screw : C.B.P.(P2) M3x8 (tightening torque:5-7 kgf.cm)
(The numbers shown in the figure indicate the order of tightening the screws.)
2
Positioning Hole and
Guide Pin
Figure 4-42. Removing the Printer Mechanism (3)
Revision B
CDR Guide Sensor
CDR Guide Sensor Cable
(No.9)
4
5
3
1
70