Fuses; Air Cleaner/Filter - Arctic Cat 2007 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
5. Trickle charge the battery at 1.5 amps for 10
hours.
! CAUTION
Never exceed the standard charging rate.
6. After charging, check fluid level and fill with
distilled water as necessary; then install vent
plugs.
! CAUTION
Before installing the battery, make sure the ignition
switch is in the OFF position.
7. Attach the vent tube and check the vent tube to
make sure it is not crimped or obstructed in any
way and that it is properly routed through and
secured to the frame.
8. Connect cables to the proper terminals: positive
cable to the positive terminal (+) and negative
cable to the negative terminal (-). Connect the
negative cable last.
! CAUTION
Connecting cables in reverse (positive to negative
and negative to positive) can cause serious damage
to the electrical system.
9. Place the battery into position in the vehicle and
secure with the battery access panel.
The main fuses are located in a power distribution
module under the operator's seat.
If there is any type of electrical system failure,
always check the fuses first.
NOTE: To remove the fuse, compress the locking
tabs on either side of the fuse case and lift out.
www.mymowerparts.com
Back
2-4

Fuses

Prowler/XT
Back to TOC
Always replace a blown fuse with a fuse of the same
type and rating.

Air Cleaner/Filter

The air filter inside the air filter housing must be
kept clean to provide good engine power and gas
mileage. If the vehicle is used under normal condi-
tions, service the filter at the intervals specified. If
operated in dusty, wet, or muddy conditions, inspect
and service the filter more frequently. Use the fol-
lowing procedure to remove the filter and inspect
and/or clean it.
CLEANING AND INSPECTING
FILTER
Failure to inspect the air filter frequently if the vehi-
cle is used in dusty, wet, or muddy conditions can
damage the engine.
1. Remove the seats; then remove the center con-
sole.
2. Unsnap the four fasteners securing the air
cleaner housing cover and remove the cover.
3. Remove the air filter/filter screen assembly and
separate the foam filter from the screen.
1411-576
Back to Section TOC
! CAUTION
! CAUTION
PR101
Next