FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
Steering Wheel
REMOVING
1. Remove the steering wheel cover; then match
mark the steering shaft and steering wheel.
NOTE: Any time steering components are disas-
sembled, all connecting components should be
marked for proper alignment during assembling.
2. Remove the nut securing the steering wheel and
remove the steering wheel. Account for the flat
thrust-washer and two wave washers.
INSPECTING
1. Inspect the steering wheel for cracks, missing
padding, or broken spokes.
2. Inspect the splines for wear.
3. Check that the steering wheel is not bent.
INSTALLING
1. Place the flat thrust-washer and then the two
wave washers onto the steering shaft.
www.mymowerparts.com
Back
8-4
PR324A
PR226
Back to TOC
2. Install the steering wheel aligning the two match
marks; then apply a drop of red Loctite #271 to
the threads of the nut and secure the steering
wheel. Tighten to specifications.
NOTE: If a new steering wheel is being installed,
mark the wheel as close as possible to the old
wheel mark; then check for proper positioning with
the front wheels straight forward.
3. Install the steering wheel cover and secure with
the existing hardware. Do not over-tighten.
Steering Wheel Shaft
REMOVING
1. Remove the steering wheel (see Steering Wheel
in this section).
2. Remove the six torx-head screws securing the
dash panel to the frame and one cap screw and
nut from the center support.
3. Slide the dash panel rearward to access the
upper steering shaft joint; then remove the cap
screw securing the upper shaft joint to the steer-
ing wheel shaft.
Back to Section TOC
PR181A
PR475A
Next