Carburetor Specifications; Carburetor Schematic; Carburetor - Arctic Cat 2007 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983

Carburetor

Specifications
PROWLER/XT
Type
Main Jet
Slow Jet
Pilot Screw Setting (turns)
Needle Jet
Jet Needle
Idle RPM
Starter Jet
Float Arm Height

Carburetor Schematic

KEY
1. Cover 14. Float Set
2. Screw 15. Float Pin
3. Spring 16. Pilot Screw
4. Vacuum Piston 17. Spring
5. Spring Seat 18. Washer
6. Jet Needle 19. O-Ring
7. Needle Jet 20. Idle Adjust
8. Jet Holder
21. Washer
9. Main Jet
22. Spring
10. Slow Jet
23. Plate
11. Starter Jet
24. Screw
12. Float Valve
25. Electric Choke
13. Clip
26. Choke Cover
www.mymowerparts.com
4-2
Keihin CVK36
132
40
1 1/4
6.0/4.0
Fixed
1250-1350
85
17 mm (0.7 in.)
27. Float Chamber
Assy
28. Screw
29. Spring
30. Diaphragm
Assy
31. Pump Housing
32. U-Ring
Screw
33. Screw
34. O-Ring
35. Screw
36. Screw
37. Cover
38. Vent Hose
0741-115
Back to TOC
Carburetor
! WARNING
Whenever any maintenance or inspection is per-
formed on the fuel system during which there may
be fuel leakage, there should be no welding, smok-
ing, open flames, etc., in the area.
REMOVING
1. Remove the seats and center console; then
remove the left-side seat-base.
2. Loosen the clamps on the inlet boot; then
remove the boot from the left-side.
3. Loosen the clamp securing the intake boot to the
carburetor; then separate the carburetor from the
boot.
4. Remove the gas hose and carburetor float cham-
ber vent hose.
5. Remove the throttle arm cover; then loosen the
outer jam nut on the throttle cable and discon-
nect the throttle cable from the carburetor.
Back to Section TOC
PR160A
PR154A
Next