Frame/Welds; Electrical Connections; Hydraulic Brake System - Arctic Cat 2007 Service Manual

FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
4. Turn the linkage rod clockwise or counterclock-
wise until the lower linkage hole aligns with the
shift arm pin.
5. Install the bushing and linkage and secure with
the washer and E-clip; then tighten the jam nut
securely. Check each gear shift position for
proper gear selection and make sure the proper
icon illuminates on the LCD.

Frame/Welds

The frame and welds should be checked periodically
for damage, bends, cracks, deterioration, broken
components, and missing components. If replace-
ment or repair constitutes removal, see Section 8.

Electrical Connections

The electrical connections should be checked peri-
odically for proper function. In case of an electrical
failure, check fuses, connections (for tightness, cor-
rosion, damage), and/or bulbs. If an electrical com-
ponent needs to be tested for proper function, see
Section 5.
Hydraulic
Brake System
CHECKING/BLEEDING
The hydraulic brake system has been filled and bled
at the factory. To check and/or bleed a hydraulic
brake system, use the following procedure.
www.mymowerparts.com
Back
2-14
PR461A
Back to TOC
1. With the master cylinder in a level position,
check the fluid level in the reservoir. If the level
in the reservoir is not above the MIN, add DOT
4 brake fluid.
2. Depress the brake pedal several times to check
for a firm brake. If the brake is not firm, the sys-
tem must be bled.
3. To bleed the brake system, use the following
procedure.
A. Remove the cover and fill the reservoir with
DOT 4 Brake Fluid.
B. Install and secure the cover; then slowly
depress the brake pedal several times.
C. Remove the protective cap, install one end of
a clear hose onto one FRONT bleeder screw,
and direct the other end into a container; then
while holding slight pressure on the brake
pedal, open the bleeder screw and watch for
air bubbles. Close the bleeder screw before
releasing the brake pedal. Repeat this proce-
dure until no air bubbles are present.
Back to Section TOC
PR095
AF637D
Next