Table of Contents
Advertisement
Position Command Connections
Connecting the NI 9512 to a P-Command Drive
Note
Refer to the NI SoftMotion Module book of the LabVIEW Help for information about
chassis, slot, or software restrictions.
Note
Many p-command drive manufacturers refer to the Step± signal as Pulse± and the
Direction± signal as Sign±.
© National Instruments Corporation
This Appendix contains information about using the NI 9512 drive
interface module with drives that support position command mode or pulse
command input.
Complete the following steps to connect the NI 9512 drive interface
module to p-command drives and other I/O:
1.
Install the module in the chassis as specified in the chassis
documentation.
2.
Connect the module to a drive and other I/O using the NI 951x 37-pin
terminal block and NI 951x 37-pin terminal block cable or a custom
cable.
B-1
B
NI 951x User Manual
Advertisement
Table of Contents
