Section 4: PowerTool Interface
4.4.6 PIP (Picture-in-Picture) Tab
Picture in Picture
Enable Picture in Picture – •Activates the PIP window and enables the
controls on the tab. PIP functions only when you have an active signal
and are not running a test pattern. If you have no active signal, the
following warning is displayed (No Active Video Signal/
Image Settings Controls Disabled) and the PIP Image
controls are disabled.
Size and Position
Position Presets – Allows you to set the position of the PIP window:
•
•
•
•
•
•
H-Position/V-Position – Indicates the horizontal/vertical position of the
picture-in-picture window. The range is a number in pixels. This control is
enabled when you select the Custom option from the Position Presets
list.
PIP Size – Indicates the width of the PIP window in pixels. The height of
the window is determined using the default aspect ratio of the input image.
This control is enabled when you select the Custom option from the
Position Presets drop-down list.
4-14
Top Left
Top Right
Bottom Left
Bottom Right
Custom
Picture By Picture (places the two windows side by side)
Figure 4-13 PIP
PowerTool 2.1 User Manual
020-100035-03 Rev. 1 (12-2010)