Section 3: Working with PowerTool
firewall may not be configured correctly. If some projectors are found
and others are not, you may have problems with one or more of the
following: duplicate IDs or IP addresses, incorrect IP addresses, or
incorrect firewall configuration.
3.
Click Search. PowerTool detects all the projectors that are connected.
Projectors flagged with the message "COMM ERROR" have been
NOTE:
detected, but are not responding to communication. They cannot be selected
for configuration until the communication problem has been resolved.
4.
Click a projector to select it. To deselect it, click it again. To select all of
the projectors shown, click Select All. To clear your selection, click
Deselect All.
5.
Click Next to add the projectors to the configuration. Projectors are
added in the order they are selected.
3-4
Figure 3-4 Projectors found
PowerTool 2.1 User Manual
020-100035-03 Rev. 1 (12-2010)