Table of Contents
Advertisement
Section 3: Working with PowerTool
3.2 Working With Configuration Files
The settings that you specify for your projectors can be stored for future use
in PowerTool configuration files, so that you don't have to repeat setup that
you have already done. When you launch PowerTool, there is a new, empty
configuration already loaded. You can begin using this and save it later, or
you can open an existing configuration that you have already created.
3.2.1 Open a Configuration File
1.
Click the PowerTool button and select Open. You can also select a
recently used configuration file by clicking it in the Recent
Documents list.
2.
Browse to and select the configuration file to load. Click Open.
NOTE:
configuration file into the projector workspace. Red (Status Unknown)
indicates projectors that are in an error condition, or projectors that are
not connected as recorded in the configuration file.
3.2.2 Save a Configuration File
1.
To save the configuration file, click the PowerTool button and select
Save As.
2.
Browse to the folder where you want to save the file, specify a file
name, and click Save.
3.3 Adding Projectors to the Configuration
You can use PowerTool to search for projectors for you, or you can add them
to your configuration manually.
3-2
Figure 3-2 PowerTool Menu
PowerTool automatically loads the projectors in the
PowerTool 2.1 User Manual
020-100035-03 Rev. 1 (12-2010)
Advertisement
Table of Contents
