Powertool Ribbon - Christie PowerTool User Manual

Section 4: PowerTool Interface

4.2 PowerTool Ribbon

The Control tab on the tool ribbon provides quick access to the most
commonly used controls. Other options are grouped by function under the
tabs in the PowerTool window.
Power – On/Off turn the selected projectors on or off. When powering on
or off, the status lights of the affected projector(s) turn medium green and the
ON/OFF buttons for the affected projector(s) are disabled until the cycle is
complete.
If multiple projectors are selected, but only some of them are on, both
buttons are available. Clicking the On button powers up the selected
projectors that are not already on.
When turning a projector on, you might be prompted to confirm this action.
Channel – Backup / Restore back up and restore channel settings for the
selected projector(s). See
Preferences.
Preferences – Backup / Restore back up and restore projector
preferences for the selected projectors. See
Channels or
Control Panel
Input Signal – Sets the input source for the selected projectors. If
multiple projectors are selected, only the sources that are common to all
the selected projectors are included in the list. See the projector manual
for information about supported input sources.
4-2
Figure 4-2 PowerTool Menu
Figure 4-3 PowerTool Ribbon, Control Tab
Section 5.1 Back Up Projector Channels or
Preferences.
Section 5.1 Back Up Projector
PowerTool 2.1 User Manual
020-100035-03 Rev. 1 (12-2010)