Section 4: PowerTool Interface
4.4.2 Control Tab
Information
These fields are disabled when multiple projectors are selected.
Projector Name – Identifies the selected projector by name. This is a
PowerTool reference only and is not stored on the projector.
Projector ID – Identifies the selected projector's ID number.
Connection – Identifies the selected projector's IP address/COM port.
Source
Auto Setup: – Optimizes settings for the current source. Auto Setup will
override settings you may have adjusted. Table 4.1 outlines the Auto Setup
changes. PowerTool will prompt you to confirm that you want to use Auto
Setup. You must have an unlocked channel present to use Auto Setup. If
multiple projectors are selected, Auto Setup will be run on each selected
projector in succession. Failures will be reported. Auto Setup is not available
if the selected Input Signal source is inactive.
Table 4.1 Auto Setup Settings
Pixel tracking
Pixel phase
Size and blanking
Vertical stretch
Position
Input levels
4-6
Figure 4-6 Control Tab
Contrast
Brightness
Auto input level (Off)
Detail (if video source)
Filter
Luma delay
PowerTool 2.1 User Manual
020-100035-03 Rev. 1 (12-2010)