Surround Panel Installation - Travis Industries DVL GSR Owner's Manual

18
Installation (for qualified installers only)

Surround Panel Installation

PANEL SIZE
4" x 6"
8" x 10"
10" x 13"
NOTE: The insert may be installed without surround panels.
NOTE: The insert may be installed
without surround panels.
1 Follow the directions to the
right to install the side panels.
2 Follow the directions below to
install the top panel.
Top
Panel
a
Install the top panel so
the tabs insert into the
joggle clips on the top
panel
© Travis Industries
WIDTH
40"
44-3/16"
48-3/16"
b
Line up each side surround
panel and insert two screws from
the inside to secure in place.
Top Trim
Spring
Clips
"L" Bracket
Right Side Trim
4091008
HEIGHT PART #
29" 96100320
33-3/8" 96100321
36-3/8" 96100322
Micro (1/16")
Standard
Screwdriver
b
Top Trim
"L" Bracket
Right Side
Trim
Trim Installation:
Insert one leg of each "L" bracket into the top
and side trim piece. Align the trim to form a
precise corner, then tighten the two set
screws with a small standard screwdriver.
Slide the trim over the panels. Place the
spring clips behind the panels at the locations
shown. This keeps the trim tight against the
panel.
Optional Knock-Out
An optional knock-out is provided if the power cord is
routed behind the surround panel.
Pre-thread the holes on the surround
a
panels with the screws included in the
surround panel kit.
5/16" Nutdriver
Run the power cord to
the right of the insert.
COVER PLUGS FOR
ON/OFF SWITCH AND
RHEOSTAT
Install the button plug
and switch plug into the
surround panel trim to
conceal the mounting
holes (see the
illustration below).
100-01236_000