Maintaining Your Heater's Appearance; Battery Replacement; Receiver Battery Installation; Control Panel Light Battery - Travis Industries DVL GSR Owner's Manual

40

Maintaining Your Heater's Appearance

Fingerprints or other marks left on the optional plated surface may become etched in place if they are not
wiped clean prior to turning the heater on. Clean the plated surfaces with denatured alcohol and a soft
cloth (with the heater cool). Other cleaners may leave a film that may become etched into the surface.

Battery Replacement

Receiver Battery Installation

Install four AA batteries into the receiver (see illustration below). You can use the batteries from the
battery backup tray on the appliance. See the installation instructions for details. These batteries control
the comfort control and act as a power-backup in case the household (AC) current goes out.

Control Panel Light Battery

LED lights and a 9v battery are used to illuminate the control panel when the concealment cover is lifted. If the LED
lights do not operate, replace the 9v battery (see the illustration below). The battery holder is held in place with Velcro
and may be removed for easier access.

Transmitter Battery Installation

Install the three included AAA batteries into the remote (see illustration below).
HIGH
OFF
LOW
ACCENT LIGHT
The remote
uses 3 AAA
batteries.
© Travis Industries
Maintenance
CONTINUOUS
PILOT ON REMOTE
GREEN SMART
PILOT
4091008
Battery Holder for
Control Panel Lights
OFF
PRG
The remote receiver
uses 4 AA batteries.
100-01236_000