Log Set Installation; Rear Log Placement - Travis Industries DVL GSR Owner's Manual

Log Set Installation

! The logs are fragile, especially after being exposed to heat.

Make sure the gas control valve is "OFF" and the heater is cool prior to conducting service.

Failure to position the parts in accordance with these diagrams or failure to use only parts
specifically approved with this appliance may result in property damage or personal injury.

If using propane (LP), convert the appliance before installing the logs (see page 47).

The burner must be correctly positioned before installing the logs. Make sure the burner is fully
seated and the pilot is properly aligned. See page 47 for details on burner removal.

Rear Log Placement

The rear log has two obround holes on the bottom. Place the log so the pins on the burner insert into
the holes on the log (see photos below). Once in place, carefully pull the log all the way forward.
This allows the log to glow above the rear burner holes. NOTE: If you encounter sooting on the rear
log, move the log back until sooting is eliminated.
© Travis Industries
Finalizing the Installation
4091008
23
100-01236_000