ioMirror E3210 User's Manual
Hardware Overview
Please note that the LCD display module is an optional accessory.
Reset Button – The reset button is used to load factory defaults. Use a pointed object, such as a
straightened paper clip or toothpick, to hold the reset button down for 5 seconds. The Ready LED
will turn red as the factory defaults are loaded and will change to green when the operation is
complete.
Pin Assignments
Ethernet (CN1)
1
Pin
Signal
1
Tx+
8
2
Tx-
3
RX+
6
Rx-
44.5
1-8
Introduction
35.1
57.5