ioMirror E3210 User's Manual
Module-to-Module and Channel-to-Channel modes
Module-to-Module mode is used if you wish for all DI channels to be mapped to another
ioMirror's DO channels. Simply enter the destination IP address.
Channel-to-Channel mode is used if you wish to individually map DI channels to separate or
multiple ioMirror servers. For each DI channel, enter the mapping destination(s) using Remote
Module IP Address and Remote DO Channel. If your ioMirror will also be receiving signals
from another ioMirror server, enter the mapping source for each channel using Acceptable
Remote Module IP Address.
System Management
Accessible IP Settings
On the Accessible IP Settings page, you may control who has configuration access to the ioMirror
by entering the permitted IP Address and Netmask. When the accessible IP list is enabled, only
network hosts on the list may configure the ioMirror. Use the accessible IP list as follows:
To grant access to a specific IP address, use Netmask = 255.255.255.255.
To grant access to hosts on a specific subnet, use a non-trivial Netmask, such as
255.255.255.0.
To grant access to any network host, disable the accessible IP list. You may use the following
sample entries for reference:
Desired Hosts
192.168.1.120
192.168.1.1 to 192.168.1.254
IP Address
Netmask
192.168.1.120
255.255.255.255
192.168.1.0
255.255.255.0
3-6
Using the Web Console