Table of Contents
Advertisement
ioMirror E3210 User's Manual
Connecting the Hardware
Connecting the Power
Connect your 12 to 30 VDC power supply to the ioMirror's terminal block. If power is properly
supplied, the "Power" LED will light up red until the system is ready.
Grounding the Unit
Connect your grounding line to the wall-mount sockets or DIN-rail.
Connecting to the Network
For initial installation, connect the ioMirror to the same LAN as your host computer, through an
Ethernet switch or hub. Alternatively, you can use a straight-through Ethernet cable to connect the
ioMirror directly to the host computer.
Connecting the I/O Device
DI Dry Contact
DI Wet Contact
2-2
Hardware Installation
Advertisement
Table of Contents
