Installation; Installing Countertop Dispensers Without Legs - Follett 12 Installation, Operation And Service Manual

Installation procedures
Before you begin
• All dispensers must be installed level in both directions to ensure proper operation.
• Service and ventilation clearances: 153mm (6") on right side of dispenser, 153mm (6") at top for ventilation
and 305mm (12") at top recommended for service.
• Countertop units installed without legs provide the option of taking utilities out bottom or back of dispenser
(on wall mount units and countertop units with legs, utilities exit from back). See counter cut out drawings for
bottom exiting utilities on units with and without drain pans. For installations where utilities exit through back
of dispenser, refer to back view drawings.
• Wall mount models without drain pan are designed for use above sinks.
• Counter depth must allow front of sink to be a minimum of 597mm (23.5") from wall.

Installing countertop dispensers without legs

1. Position dispenser in desired location,
mark dispenser outline on counter and
remove dispenser.
2. Regardless of whether utilities will exit
through back or bottom of dispenser,
drill four 7/16" holes in counter to
anchor dispenser to counter (Fig. 1).
3. For utilities existing through bottom
only:
(a) Make cut out as shown in Fig. 1.
(b) Move plug from drain T to back of
unit (Fig. 2).
4. For all units: Apply a thick bead
approximately 6mm (1/4") diameter
of NSF listed silicone sealant (Dow
Corning RTV-732 or equivalent)
6mm (1/4") inside marked outline of
dispenser.
5. Carefully lower dispenser on counter in
proper position and secure to counter
with four (4) 3/8" -16NC bolts.
6. Smooth excess sealant around outside
of dispenser.
12CI400A • 12HI400A 220 V 60 Hz/230 V 50 Hz Dispensers
Fig. 1 – Counter information
407mm
(16")
305mm
12mm (.437")
(12")
diameter
connections
366mm
21mm (0.8")
(14.4")
51mm (2")
cutout for
305mm
through
(12")
bottom
39mm (1.5")
26mm (1")
404mm
(15.9")
458mm
(18")
102mm
(4")
5