Disassembly And Replacement Instructions - Follett 12 Installation, Operation And Service Manual

Disassembly and replacement instructions

Dispense chute removal
1. Remove top cover (see page 31).
2. Remove stainless front cover (see page 31).
3. Slide plastic dispense chute cover up and out to remove.
4. Remove four (4) push fasteners holding dispense tube in
place and remove tube.
Dispense wheel and drive bar removal
1. Remove all ice from storage area of dispenser.
2. Remove center thumbscrew, locking plate, two wingnuts
and backing plate from front of storage hopper (see drawing
at right).
3. Remove threaded rod, agitator, baffle, and wheel in this
sequence.
Wheelmotor removal
1. Remove dispense wheel and drive bar (see above).
2. Remove four (4) hopper/support plate mounting screws and
washers (Fig. 11.1).
3. Move hopper assembly 1/2" (13mm) to left.
4. Remove four (4) dispenser motor bracket mounting screws
and washers (Fig. 11.2).
5. Short shaft motors only: loosen only two (2) lower screws
on drive coupling and remove from motor shaft (Fig. 11.3).
6. Remove four (4) screws holding motor to mounting bracket.
Fig. 11
MOVE HOPPER ASSEMBLY 13mm (1/2") TO LEFT
dispense motor (long shaft, current)
12CI400A • 12HI400A 220 V 60 Hz/230 V 50 Hz Dispensers
drive coupling assembly
shield
mounting
bracket
threaded rod
agitator
baffle
dispense wheel
wingnut
3
2
dispense motor mounting screws
dispense motor (short shaft)
backing plate
1
mounting
screw &
washer
hopper/
support
plate
assembly
29