Disassembly And Replacement Instructions - Follett 25FB425A Operation And Service Manual

Disassembly and replacement instructions

Dispense chute removal
1. Remove dispenser front cover.
2. Slide plastic dispense chute up and out to
remove.
Dispense wheel and drive bar removal
1. Remove all ice from storage area of
dispenser.
2. Remove center thumbnut from dispense
wheel.
3. Remove thumbnuts holding baffle inside bin
and remove baffle.
4. Tilt rear of wheel up and lift off motor drive
shaft.
5. After reinstalling wheel, secure baffle
loosely with thumbnuts, but do not tighten.
6. Place a 1/8" (3.2 mm) spacer against wheel
and allow baffle to drop until it touches
spacer.
7. Tighten thumbnuts and remove spacer.
Drive bar removal
1. Remove dispense wheel from dispenser
(see above).
2. Pull drive bar out of its channel in bottom of
wheel.
Wheelmotor removal
1. Shut water off. Remove front cover.
2. Remove dispense wheel and dispense
chute covers (see above).
3. Remove splash panel. Water line to
solenoid valve can be disconnected from
water inlet valve by pulling on ring at end of
inlet fitting.
4. Disconnect wiring to panel and set panel
aside.
5. Disconnect wires on motor.
6. Remove four bolts (7/16" socket) holding
motor assembly to bottom of dispenser.
7. Remove motor assembly.
Fig. 2
baffle
dispenser
front
side view wheel section
25FB425A/W, 50FB425A/W
1/8" (3.2 mm)
spacer
15