Advertisement
Press the FrL/O softkey to add a found frequency to the lockout
list.
Press the MODE softkey to change the receive mode (AM, FM,
NFM) from the default for the current frequency range (au).
Press STOR to create a new CONV object using the found
frequency.
Use the keypad to enter a new frequency, and press
make that the TUNE frequency.
Using
frequency from the other mode into TUNE. For example,
pressing
load the control channel frequency into the TUNE mode if the
control channel frequency is the last frequency that the scanner
checked while scanning.
Dedicated TUNE mode will always check for the presence of
encoded squelch and digital modulation each time it finds an
active frequency. If a valid encoded squelch code is found, it will
be shown on the display, and stored automatically when you
press STOR to create a new CONV object.
Dedicated TUNE mode also displays information about trunking
control channels and trunked voice channels it finds while tuning
through the RF spectrum. The following information is displayed
for the various trunking modes:
Motorola 3600 baud control
channel
P25 9600 BPS control channel
PSR-500 User Manual
Page
FUNC TUNE
from any other mode will load the last active
FUNC TUNE
while parked on a trunked radio TGRP will
Trunked Mode
ENT
Analysis Display
qq% SID:ssss Stt
where qq=decoding quality of the
control channel data, SID=System ID,
and S=Site Number
qq% Nnnn W:wwwww
Sys:sss Rrr Stt
where qq=decoding quality of the
control channel data, N=NAC,
W=WACN, SYS=System ID, R=RFSS,
and S=Site Number
to
75
Advertisement
