Advertisement
NOTE: Use caution with DUPE. As soon as you press DUPE, a duplicate of
Basic Scanning Operation
Now that you have entered a few CONV or TGRP objects you
can experiment with Scan and Manual operation.
Activating Scan Mode will cause your scanner to scan through all
Scannable Objects that are members of enabled Scan Lists and
are not locked out. Manual Mode allows you to browse the
Scannable Objects you have created so you can select just one
to monitor.
To activate Scan Mode, just press the
Unless you have explicitly changed Scan List membership, all of
the objects you have entered so far should be mapped to Scan
List 01, and your scanner should begin scanning these objects
immediately when you press the
indicates Scan Mode as follows:
>>
1.........
..........
Study the two rows under the "Scanning" display. Each space
represents the status of a Scan List in your radio. The top row of
numbers represents Scan Lists 1 through 10, and the bottom row
represents Scan Lists 11 through 20. Unless you have already
enabled other Scan Lists in your radio, you will only see the
number "1" in the top row. All of the other spaces contain "."
symbols, which indicates that these other Scan Lists are
currently not enabled.
If you have included one or more TGRP objects in your
programming, and are within range of the trunked radio system
for those TGRPs, you will see the
the radio is scanning. The
receiving control channel data from a trunked radio system.
To pause the scanner on an active object so that the scanner
does not resume scanning, press the
scanner is stopped on that object, and press
PSR-500 User Manual Page
the selected object is created and saved in memory. Be certain to
delete any DUPEd objects that you create accidentally.
Scanning
<<
pri
SCAN
key on the keypad.
SCAN
key. The scanner display
icon flash periodically while
icon indicates that the scanner is
PSE
(Pause) key while the
PSE
SCAN
or
to
44
Advertisement
