Advertisement
GLOB
Parameter
Color 0-7
Qtxt1-0
Key Repeat
LCD BlinkOff
LCD BlinkOn
LED BlinkOff
LED BlinkOn
Pri Channels
Pri Interval
TGRP Pri Int
QuickPriRtn
Search Delay
SRCH Dig AGC
SRCH SuprTrk
TLO=FUNC L/O
DupeChecksSQ
TGID Format
TGRP Ignore
ShowCCInfo
PSR-500 User Manual
Page
Options
Red/Green/Blue (RGB)
value
Text value
On or Off
1-250 x 10 mS
1-250 x 10 mS
1-250 x 10 mS
1-250 x 10 mS
0-250
2-100 x 100 mS
On or Off
On or Off
1-100 x 100 mS
On or Off
On or Off
On or Off
Yes or No
Norm, DEC or HEX
Yes or No
Yes or No
Description
Sets intensity of red, green and blue LEDs. Press
SEL
to edit colors. Use keys to scroll to R, G
or B LED settings. Use numeric keys to activate
preset intensity levels for each LED, or use
keys to fine scroll intensity.
Sets QTXT (QuickText) 0-9 text. Use "$" to indicate
end of text.
Toggles key repeat mode when a key is held down
For alternating text displays, sets the display time
for the secondary display element.
For alternating text displays, sets the display time
for the primary display element.
When the ALERT LED setting for an object is set to
Flash, this is the amount of time the LED stays
turned off.
When the ALERT LED setting for an object is set to
Flash, this is the amount of time the LED stays
turned on.
Number of priority CONV channels to check during
a priority scan sampling. "0" samples all CONV
priority channels.
Conventional frequency priority sample interval.
Toggles priority interrupt scanning during trunked
calls
When on, does not wait for verification of correct
CTCSS, DCS or NAC when returning to an active
CONV channel after priority sampling
Sets wait for reply delay for all search modes
Sets digital AGC mode on or off for all search types.
Useful to compensate for low or high digital audio
levels caused at the system.
Alternative DSP decoding algorithm is applied to all
search types. May help reception on some
systems.
Controls the operation of the
L/OUT
pressing
performs a Temporary Lockout of
the selected object. When On, pressing
performs a Permanent Lockout of the selected
object.
If set to Yes, dupe checking will check both the
stored frequency and any encoded squelch settings
when checking for duplicate CONV objects.
Selects TGID display format
If set to Yes, TGRP wildcards will ignore calls on
previously stored TGRPS that are mapped to
disabled Scan Lists.
For Motorola and P25 systems, shows current
control channel index (from TSYS frequency list)
and frequency alternating with the voice frequency.
L/OUT
key. When Off,
L/OUT
102
Advertisement
