Advertisement
the rear of the radio. Press down on the belt clip until it locks in
place. Slide the belt clip over your belt, pocket or waistband.
NOTE:
You can order a replacement belt clip from GRE America
(
becomes lost or damaged.
Using AC Power
You can power the scanner using a supplied AC adaptor.
WARNING:
You must use the supplied AC adapter.
• Always connect the AC adaptor to the scanner before you
connect it to AC power. When you finish, disconnect the
adaptor from AC power before you disconnect it from the
scanner.
• The correct orientation for the enclosed power adaptor is in a
vertical or floor-mount position.
To power the scanner using an AC adaptor, connect the plug into
the scannerʼs PWR DC 9V jack. Then connect the AC adaptor to
a standard AC outlet.
WARNING:
To prevent electric shock, do not use the AC adaptorʼs polarized
plug with an extension cord, receptacle, or other outlet unless
you can fully insert the blades to prevent blade exposure.
Using Vehicle Battery Power
You can power the scanner from a vehicleʼs 12V power source
(such as cigarette-lighter socket) using a 9VDC at least 500-mA
adaptor with 4.75mm outer/1.7mm inner plug. Its center tip must
be set to positive and its plug must fit the scannerʼs PWR DC 9V
jack. Using an adaptor that does not meet these specifications
could damage the scanner or the adaptor.
WARNING:
Always connect the DC adaptor to the scanner before you
connect it to the power source. When you finish, disconnect the
adaptor from the power source before you disconnect it from
To power the scanner using a DC adaptor, connect the plug into
the scannerʼs PWR DC 9V jack. Plug the other end of the DC
adaptor into your vehicleʼs cigarette-lighter socket.
PSR-500 User Manual
Page
http://www.geramerica.com
the scanner.
if the one that came with your radio
32
Advertisement
