Advertisement
NOTE: When a signal is being received, the Band softkey (F1) changes to
the F1 key function is FrL/O.
Operation of the dedicated Spectrum Sweeper mode is almost
identical to that of the object mode, with one exception. When
running the Spectrum Sweeper as a Scannable Object, you must
use the object menu to enable or disable the Spectrum Sweeper
sub-bands when operating in Scan Mode. When dedicated
Spectrum Sweeper mode is used, you may press the numeric
key on the keypad that corresponds with the sub-band you wish
to enable or disable. Disabling a sub-band will cause the
Spectrum Sweeper system to skip the frequencies within that
sub-band as it performs its sweeps. The sub-bands are defined
as follows:
0: 25-54 MHz
1: 108-137 MHz
2: 137-174 MHz
VHF High Band
3: 216-300 MHz
220 MHz Commercial/Amateur Band
4: 300-406 MHz
5: 406-470 MHz
UHF Band
6: 470-512 MHz
PSR-500 User Manual Page
FrL/O. You can access the Band softkey by pressing FUNC F1 when
VHF Low Band
VHF Aircraft Band
UHF Military Air Band
UHF-T Band
73
Advertisement
