Advertisement
SRVC
Parameter
Tag
L/Out
LED Mode
LED Color
Latch LED
Backlight
Alarm
Fav
EXPERT BELOW
Modulation
Atten
Delay
Delay Time
Zeromatic
Search Dir
Hit Count
PSR-500 User Manual
Page
Options
Alpha-numeric text
On or Off
Solid or Flash
0-7
On or Off
On, Off or Flash
None, Chirp, Hi-Lo, Alert,
Ring, 2-Chirp, Fast Hi-Lo,
DTMF#
On or Off
AM, FM, NFM, AU
On or Off
On or Off
1-200
On or Off
Up or Down
Numeric value
Description
The alphanumeric display name for the SRVC
search. Use the standard text entry method or
QTXT to name the object.
Permanent lockout for the SRVC object. Also
FUNC L/OUT
accessed by pressing
scanner is stopped on the SRVC object.
Controls whether the ALERT LED flashes or
remains on solid when the ALERT LED is used.
Sets LED color to 0-7 as defined in the GLOB
menu. By default, 0=LED Off, 1=Red, 2=Yellow,
3=Green, 4=Cyan, 5=Blue, 6=Magenta, 7=White.
Normally the ALERT LED is active only while the
object is receiving a transmission. When Latch is
on, the ALERT LED will remain lit after the
transmission is complete, unless overridden by a
subsequent object that is also using the ALERT
LED.
Controls whether the backlight should be on, off or
flashing while the object is active.
Sets the Audible Alarm for the SRVC object. When
an Audible Alarm is selected, the selected alarm will
play anytime the scanner stops for activity on the
SRVC object while scanning.
When On, the SRVC object is a member of the
Favorites Scan List.
Modulation setting for the SRVC search. In most
cases AU will work fine. Use AM to override and
force AM modulation, FM to force FM modulation,
NFM to force narrow FM modulation.
When on, applies 20 dB of attenuation to all hits
received on the SRVC search. Useful in areas
where interference from nearby strong signals is
present.
Controls whether a Delay is used to wait for reply
traffic after a transmission on the SRVC search.
Sets the amount of time (in 100 millisecond
intervals) for the wait for reply delay if Delay is On,
e.g., 20=2 seconds.
When on, enhances the scannerʼs ability to lock on
to the actual center frequency of a search hit
instead of an adjacent frequency.
Sets search direction used when SRVC object is
active.
Increments each time a transmission is received on
the SWPR object. Global "Hit Counts" must be set
Dflt
to ON. Press the
softkey to reset to 0.
while the
112
Advertisement
