Advertisement
battery compartment, then replace the battery compartment door
by placing it back over the batteries and sliding it upward gently
until it locks in place.
NOTE:
Two battery holders are included with your PSR-500. The black
battery holder should be used with non-rechargeable alkaline
batteries
500 mA. If desired, you may use rechargeable batteries in the black
WARNING:
Never place non-rechargeable batteries in the yellow holder.
Intentionally or accidentally recharging non-rechargeable
batteries will cause them to overheat, leak or explode. Dispose
of rechargeable batteries properly by taking them to an
battery recycling services - check with your local solid waste
WARNING:
Always remove old or weak batteries. Batteries can leak
chemicals that destroy electronic circuits. Do not mix old and
capacities.If you do not plan to use the scanner with batteries
chemicals that can destroy electronic parts. When you charge
Ni-Cd batteries, do not over charge them. Overcharging
shortens battery life.
Attach the antenna
Remove the antenna from its protective plastic wrapper. Align the
slots on the antennaʼs BNC male connector with the posts on the
radioʼs BNC female connector and slide the antenna in place,
then rotate the antennaʼs BNC connector 1/4 turn clockwise until
it snaps in place.
NOTE:
If desired, you may also connect a mobile or base station antenna
equipped with a BNC male connector to the antenna connector
PSR-500 User Manual
Page
batteries. The yellow battery holder should be used with
rechargeable NiMH or NiCAD batteries. The radio will charge the
when the yellow holder is used in conjunction with the
supplied AC adapter or other external 9 VDC power supply rated at
holder. They will not be charged while installed in the radio.
approved battery recycling facility. Many communities offer
management agency.
new batteries, different types of batteries (alkaline, or
rechargeable), or rechargeable batteries of different
for a month or longer, remove the batteries. Batteries can leak
27
Advertisement
