Removing The Gimbal; Installing The Conduit Plug; Figure 2-2 Mounting Holes And Removed Gimbal - Honeywell HD4DIP Reference Manual

Removing the Gimbal

Installing the Conduit Plug

Document 800-00249 Rev C
08/08
To gain better access to the mounting holes and the wiring board, remove the gimbal from
the enclosure base.
Figure 2-2 Mounting Holes and Removed Gimbal
1. Squeeze the 4
black tabs until
they are free of the
black clips.
2. Elevate the hinge
until the gimbal is
above the housing
and you have
access to the
camera board
connections and
mounting holes.
Your HD4DIP(X) camera enclosure comes with a conduit plug pre-installed in the 3/4 inch
conduit entry on the back. This plug may be removed and installed in the side 3/4 inch
conduit entry (see Figure 2-3).
HD4DIP Network Camera Reference Guide
Black tabs (x4)
Metal
hinge
Black clips (x4)
Mounting
holes
21