Installation and Setup
Setscrew (loosen to
adjust horizontal
rotation)
Set focal length
(bottom)
Adjusting the Lens Focus
TECH TIP!
26
3.
Adjust the gimbal assembly to the desired view.
4.
Re-tighten the locking screw to lock the gimbal assembly in place.
Note
Orient the camera as shown in
orientation.
Figure 2-8
Gimbal Adjustment
Top view
Loosen set screw to adjust
Tilt Rotation (A)
Lenses are pre-focused at the factory. They might require a final adjustment after
installation because the optical effect of the bubble might cause a slight defocusing of
the lens.
To check the focus, hold the bubble over the lens while making any adjustments.
To adjust the camera direction, view angle, and focus, connect the local video out to the
video monitor using the supplied BNC video cable.
Figure 2-8
to maintain the correct picture
Angle view
Legend
A = Tilt rotation
B = Horizontal rotation
C = Pan rotation