IP Camera Web-Client
Compression Settings
50
Connect external devices such as sirens or flashing lights to the alarm output connector to
signal users of the camera that an alarm is activated. Set the Alarm Output as Normally
Open or Normally Close. See
When an alarm input event is detected, an alarm message appears on the Web-Client
screen (see
Figure
4-6) to notify the operator.
Note
You must click Apply after you make changes to any settings to save those
changes. Settings will not be saved unless you click Apply.
Figure 4-7
Device Settings
The video signal sent to the Web-Client from the camera has a number of settings that can
be edited which effect the video as its displayed in the Web-Client. The Compression
Settings view enables you to configure settings such as Resolution, Frame Rate and Picture
Quality.
Connecting Alarms
on page
26
for more information.