Figure 2-8 Gimbal Adjustment - Gimbal Top View - Honeywell HD3HDIH User Manual

HD3 equIP
HD3MDIH, HD3MWIH(X) Top view
Local
video
out
Adjust
focus
(top)
Set focal
length
(bottom)
Document 800-07361V5 Rev A
07/2013
®
Series H.264 Indoor High Resolution True Day/Night IP Dome Camera User Guide
Note If your installation involves a 24 V AC power source, then please wait
approximately 60 seconds after connecting to a power source for video to
appear on the local video out.
2. Connect the supplied video cable to the local video out connector to view the video
signal on a standard monitor (see
3. Loosen the setscrew that locks the gimbal assembly in place (see
adjust the horizontal rotation.
Figure 2-8 Gimbal Adjustment - Gimbal Top View
Loosen set screw to adjust Tilt Rotation
4. Adjust the gimbal assembly to the desired view. Adjust the horizontal, pan, and tilt
rotations so that the area of interest is at the center of the field of view. See
on page 28.
Figure 2-8) below to connect a local video monitor).
HD3HDIH(X) Top view (Auto Focus)
Local
video
out
Figure 2-8) to
Figure 2-9
27