Installation and Setup
Using the Grommet
Mounting the Camera
22
Figure 2-3
Conduit Plug Installation
WARNING!
To minimize moisture leaking into the camera housing,
position the enclosure with the conduit pointing down. After
feeding the cables through (see Wiring, page 23), apply an
appropriate sealant around the conduit connection.
If a conduit is not used for cable routing, install the rubber grommet in the conduit hole, then
slit the grommet and feed the cables through (see Wiring, page 23). Seal the grommet to
prevent moisture from entering the housing.
Mount the camera to a wall or ceiling using the supplied screws (see
Mounting Surface
on page 20).
Back entry conduit
Side entry conduit
Conduit plug
Preparing the