Dot1X Messages - Cisco Catalyst 3750-X Message Manual

Hide thumbs Also See for Catalyst 3750-X:
Table of Contents

Advertisement

Chapter 2
Message and Recovery Procedures
Error Message DHCP_SNOOPING-6-VLAN_NOT_SUPPORTED: Vlan not supported. [dec] bindings
ignored.

DOT1X Messages

Error Message DOT1X-4-MEM_UNAVAIL: Memory was not available to perform the 802.1X
action. AuditSessionID [chars]
Error Message DOT1X-4-PROC_START_ERR: Dot1x unable to start.
Error Message DOT1X-4-UNKN_ERR: An unknown operational error occurred.
Error Message DOT1X-5-ERR_CHANNELLING: Dot1x cannot be enabled on Channelling ports.
Error Message DOT1X-5-ERR_DYNAMIC: Dot1x cannot be enabled on Dynamic ports.
OL-9772-05
Explanation
The specified number of bindings were ignored when the switch read the database file
because the VLAN is no longer configured on the switch. [dec] is the number of bindings that the
switch ignores.
Recommended Action
No action required.
The system memory is not sufficient to perform the 802.1x authentication. [chars] is the
Explanation
session ID.
Reduce other system activity to reduce memory demands.
Recommended Action
Explanation
The system did not start the 802.1x process.
Restart the 802.1x process by entering the dot1x system-auth-control global
Recommended Action
configuration command. If this message recurs, reload the device.
Explanation
The 802.1x process cannot operate because of an internal system error.
Reload the device.
Recommended Action
802.1x authentication could not be enabled on the EtherChannel port. An attempt to set
Explanation
802.1x port control to auto or to force-unauthorized mode on the channel port, which is not
allowed, caused this condition.
Disable the EtherChannel on the interface, and then re-enable 802.1x
Recommended Action
authentication.
802.1x authentication could not be enabled on the dynamic-mode port. An attempt to
Explanation
set 802.1x port-control to auto or force-unauthorized mode on a dynamic mode port, which is not
allowed, caused this condition.
Disable dynamic mode on the interface, and then try 802.1x authentication.
Recommended Action
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
DOT1X Messages
2-21

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 3560-xCatalyst 3560-eCatalyst 3750-e

Table of Contents