Dhcp_Snooping Messages - Cisco Catalyst 3750-X Message Manual

Hide thumbs Also See for Catalyst 3750-X:
Table of Contents

Advertisement

DHCP_SNOOPING Messages

Error Message CMP-5-REMOVE: The Device is removed from the cluster (Cluster Name:
[chars]).
DHCP_SNOOPING Messages
Error Message DHCP_SNOOPING-3-DHCP_SNOOPING_INTERNAL_ERROR: DHCP Snooping internal
error, [chars].
Error Message DHCP_SNOOPING-4-AGENT_OPERATION_FAILED: DHCP snooping binding
transfer failed. [chars].
Error Message DHCP_SNOOPING-4-AGENT_OPERATION_FAILED_N: DHCP snooping binding
transfer failed ([dec]). [chars].
Error Message DHCP_SNOOPING-4-DHCP_SNOOPING_ERRDISABLE_WARNING: DHCP Snooping
received [dec] DHCP packets on interface [chars].
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
2-18
Explanation
The device is removed from the cluster. [chars] is the cluster name.
No action is required.
Recommended Action
A software sanity check failed in the DHCP snooping process. [chars] is the error.
Explanation
Recommended Action
Copy the message exactly as it appears on the console or in the system log.
Research and attempt to resolve the error by using the Output Interpreter. Use the Bug Toolkit to
look for similar reported problems. If you still require assistance, open a case with the TAC, or
contact your Cisco technical support representative, and provide the representative with the gathered
information. For more information about these online tools and about contacting Cisco, see the
"Error Message Traceback Reports" section on page
Explanation
The DHCP snooping binding transfer process failed because of the specified reason for
failure. [chars] is the reason for the failure.
Recommended Action
No action is required.
Explanation
The DHCP snooping binding transfer process failed because of the specified reason for
failure. [dec] is the number of failures, and [chars] is the reason for the failure. This message is
rate-limited.
Recommended Action
No action is required.
Explanation
The switch detected a DHCP packet rate-limit violation on the specified interface and
put the interface in the error-disabled state. [dec] is the number of DCHP packets, and [chars] is the
interface.
No action is required.
Recommended Action
Chapter 2
Message and Recovery Procedures
1-7.
OL-9772-05

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Catalyst 3560-xCatalyst 3560-eCatalyst 3750-e

Table of Contents