Cisco Catalyst 3750-X Message Manual page 49

Chapter 2 Message and Recovery Procedures
Error Message EC-5-ERRPROT: Channel protocol mismatch for interface [chars] in group
[dec]: the interface can not be added to the channel group.
Explanation
the interface, and [dec] is the channel group.
Recommended Action
Error Message EC-5-ERRPROT2: Command rejected: the interface [chars] is already part
of a channel with a different type of protocol enabled.
Explanation
a channel with a different protocol. [chars] is the interface.
Recommended Action
Error Message EC-5-ERRPROT3: Command rejected: the interface [chars] is already part
of a channel.
Explanation
of a channel group. [chars] is the interface.
Recommended Action
Error Message EC-5-L3DONTBNDL1: [chars] suspended: PAgP not enabled on the remote
port.
Explanation
In this mode, the port is placed in a suspended state. [chars] is the Layer 3 interface.
Recommended Action
configuration command.
Error Message EC-5-L3DONTBNDL2: [chars] suspended: LACP currently not enabled on the
remote port.
Explanation
mode, the port is put in a suspended state. [chars] is the interface name.
Recommended Action
Error Message EC-5-L3DONTBNDL3: [chars] suspended: LACP not enabled on the remote
port.
Explanation
enabled. In this mode, the local port is put in a suspended state. [chars] is the interface name.
Recommended Action
OL-9772-05
The interface cannot be added to the channel group with the specified mode. [chars] is
Change the channel group or the mode for the interface.
The interface cannot be selected for the specified protocol because it is already part of
Remove the interface from the channel group.
The interface cannot be unselected for the specified protocol because it is already part
Remove the interface from the channel group.
PAgP is enabled on the Layer 3 interface but the partner port is not enabled for PAgP.
Enable PAgP on the remote side by using the channel-group interface
LACP is enabled on a Layer 3 interface but is not enabled on the partner port. In this
Enable LACP on the remote side.
LACP is enabled on a Layer 3 interface but the remote port does not have LACP
Enable LACP on the remote port.
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
EC Messages
2-31