Cisco Catalyst 3750-X Message Manual page 83

Chapter 2 Message and Recovery Procedures
Error Message PLATFORM_PBR-3-INSTALL_FAIL: Policy route-map [chars] not installed in
hardware.
Explanation
are forwarded to the CPU for processing. [chars] is the route-map.
Recommended Action
multiple interfaces.
Error Message PLATFORM_PBR-3-NO_LABEL: Cannot allocate label for route-map [chars].
Explanation
cannot be programmed to implement policy routing. There is a limit of 247 labels for policy routing.
[chars] is the route-map.
Recommended Action
multiple interfaces, if possible.
Error Message PLATFORM_PBR-3-UNSUPPORTED_RMAP: Route-map [chars] not supported for
Policy-Based Routing.
Explanation
supported. This is a hardware limitation. [chars] is the route-map.
Recommended Action
ip next-hop ip-address route-map configuration command to reconfigure the route map to use only
these supported actions.
Error Message PLATFORM_PBR-4-CPU_SUPPORTED_ACTION: Set action in sequence [dec] of
route-map [chars] supported by forwarding to CPU.
Explanation
is not supported in hardware, so the packets are forwarded to the CPU for processing. The route-map
actions that invoke this forwarding are set interface, set ip default next-hop, set default interface,
or set ip df. [dec] is the action number, and [chars] is the route-map.
Recommended Action
reconfigure the route map action to route the packet to the specified next hop.
Error Message PLATFORM_PBR-4-RETRY_INSTALL: Route-map [chars] installed in hardware
upon retry.
Explanation
more route-maps previously did not load because of lack of resources. [chars] is the route-map.
Recommended Action
OL-9772-05
The PBR manager could not install the complete route-map in hardware, so the packets
Simplify route-map configurations. For example, use the same route-map on
The PBR manager could not allocate a label for this route-map. As a result, the hardware
Simplify the configuration with label sharing. Use the same route-maps on
The route-map attached to an interface for policy routing contains an action that is not
Use the route-map map-tag permit global configuration command and the set
The route-map attached to an interface for policy-based routing contains an action that
Use the set ip next-hop ip-address route-map configuration command to
The PBR manager was able to fit the complete configuration into the hardware. One or
No action is required.
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
PLATFORM_PBR Messages
2-65