Cisco Catalyst 3750-X Message Manual page 41

Chapter 2 Message and Recovery Procedures
Error Message DOT1X-5-ERR_TRUNK: Dot1x can not be enabled on Trunk port.
Explanation
port control to auto or force-unauthorized mode on a trunk port, which is not allowed, caused this
condition.
Recommended Action
port.
Error Message DOT1X-5-ERR_VLAN_INVALID: The VLAN [dec] is invalid and cannot be
assiged for use on the Dot1x port [chars] Vlan
Explanation
the VLAN, and [chars] is the 802.1x port.
Recommended Action
Error Message DOT1X-5-FAIL: Authentication failed for client ([chars]) on Interface
[chars] AuditSessionID [chars]
Explanation
[chars] is the interface, and the third [chars] is the session ID.
Recommended Action
Error Message DOT1X-5-INVALID_INPUT: Dot1x Interface parameter is Invalid on
interface [chars].
Explanation
interface.
Recommended Action
Error Message DOT1X-5-INVALID_MAC: Invalid MAC address(drop, zero, broadcast or
multicast mac address) [enet] is trying to authenticate.
Explanation
MAC addresses. [enet] is the invalid MAC address.
Recommended Action
Error Message DOT1X-5-RESULT_OVERRIDE: Authentication result overridden for client
([chars]) on Interface [chars] AuditSessionID [chars]
Explanation
[chars] is the interface, and the third [chars] is the session ID.
Recommended Action
OL-9772-05
802.1x authentication could not be enabled on the trunk port. An attempt to set 802.1x
Disable trunking on the interface, and re-enable 802.1x authentication on the
The specified VLAN is out of range and cannot be assiged as an 802.1x port. [dec] is
Reconfigure the configuration to use a valid VLAN.
The authentication was unsuccessful. The first [chars] is the client ID, the second
No action is required.
The 802.1x interface parameter is out of the specified range or is invalid. [chars] is the
See the command-line help string for the valid 802.1x parameters.
Authentication using 802.1x is not allowed for zero, broadcast, and multicast source
Connect an 802.1x supported host to the 802.1x enabled port.
The authentication result was overridden. The first [chars] is the client ID, the second
No action is required.
Catalyst 3750-X, 3750-E, 3560-X, and 3560-E Switch System Message Guide
DOT1X Messages
2-23