Hydropool Hot Tub Owner's Manual page 50

tOpsIde pAnel dIsplAy MessAGes
/
Inadequate water detected in heater chamber - Check
water level in spa and add if necessary. If water level is okay,
make sure that pumps are primed and all gate valves are
fully opened. Press any topside panel pad to reset.
/
Inadequate water detected in heater chamber – displays on
third occurrence of a DR message within a 24 hour period.
The spa shuts down completely when the DRY message is
flashing on the display. Check water level in spa and add
if necessary. If water level is okay, make sure that pumps
are primed and all gate valves are fully opened. Press any
topside panel pad to reset.
/
Priming mode – occurs when spa is first powered up, or
when power has been restored after a power interruption.
Allows for safe priming of the pumps. See M7 operating
instructions for complete details.
/ /
--- --F --C
Temperature unknown – after the pump has been
operating for 2 minutes, the current water temperature will
be displayed.
/
--- ----
Temperature not current while in Economy or Sleep mode
– In either of these modes, the pump may be off for hours
in between filter cycles. To view the current spa water
temperature, either switch to Standard mode or turn on the
pump for at least 2 minutes.
/ /
Stops the control system from operating automatically to
allow filter cartridge removal. Press any topside control pad
except for P1 to return to normal operation mode.
H y d r O p O O l I n d u s t r I e s
Allows for convenient draining of the spa using the P1 low
speed. Can only be accessed while in Standby mode. Press
any topside control pad except for P1 to return to normal
operation mode.
System is operating in STANDARD mode. See operating
instructions for complete details.
System is operating in ECONOMY mode. See operating
instructions for complete details.
System is operating in STANDARD-IN-ECONOMY mode. See
operating instructions for complete details.
System is operating in SLEEP mode. See operating
instructions for complete details.
If spa water temperature is more than 20˚F (7˚C) cooler than
the set temperature, the system will automatically activate
the heater to provide freeze protection. This is a normal
function; no corrective action is necessary.
50
COntInued
/
/
/
/